Malibu Boats Sunsetter/Wakesetter LXi Specifications download pdf (Page 59)

4-5

Rudder Stuffing Box

The rudder stuffing box has a grease nipple and should be checked and lubricated

annually. The rudder stuffing box is accessed through the rear center access panel directly

below the fuel tank. Use only a marine grade, waterproof grease.

Shaft Packing

Located in the bilge, under the rear center access panel, is the shaft packing. The shaft

packing is a seal where the prop shaft goes through the hull of the boat. This seal should

be checked and tightened periodically. Please note that it is normal for a small amount of

leakage to occur from this seal. It should leak at the rate of about one drop every ten

seconds.

Fuel System

Fuel Filter

Your boat is equipped with a 1/2" in-line fuel filter

located 6 to 12 inches from the fuel tank. The filter

removes debris from the fuel being sent to the engine.

The filter should be changed after each season of boat

use. Often, fuel from lake Marinas will have a

considerable amount of debris and can eventually cause

your engine to run erratically. See your local Malibu

Dealer for servicing.

Hoses

Fuel lines, vent hoses, and drain hoses should be

checked frequently for leaks. If this is occurring around

the fitting, tightening of the hose clamps may be all t

hat is necessary. However, if the leak continues, replace

the hose immediately to prevent a build-up of fluids or gases. Surface cracking on hoses

indicates wear, and replacement is recommended. Use fuel system parts certified for

marine use only. Do not substitute with automotive parts.

Figure 4-2. In-Line Fuel Filter

Chapter 4 doc.qxd 8/26/03 5:11 PM Page 5

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 75 76

No comments

Malibu Boats Sunsetter/Wakesetter LXi Specifications Page 59