Malibu Boats Boat Specifications download pdf (Page 43)

2-23

Wedge

If your boat is equipped with the Wedge option you will

find that the unit has two positions - DOWN or UP. To

adjust wedge position, access wedge through the swim

platform door. To install in either position follow these

steps:

DOWN - To lower unit, depress spring-loaded pins

and lower until you hear Wedge pins

engaged.

UP - To raise unit, reverse procedure until locked

in the UP position.

Ensure both spring loaded pins

are engaged before taking off.

Excessive speeds over 30 MPH

could cause adverse handling

conditions. It is recommended

that you put the Wedge unit in the

UP position if you will be traveling

over these speeds.

Scarpa Suppression Plate (SSP)

The Scarpa Suppression plate is an optional add-on feature

available for boats built with the Wedge boat bracket installed,

used to enhance slalom ski wake characteristics on Response

model ski boats. The plate is installed to an existing Wedge

bracket.

Optional Malibu Launch System (MLS)

The Malibu Launch System (MLS) ballast system allows water to be stored onboard to

increase hull weight for larger wakeboard wakes. Depending on model the MLS can be

available as front and rear ballast tanks. If your boat is equipped with this feature, locate

the MLS drain and fill rocker switch on the dash accessory panel; press switch up to fill,

or down to drain.

Figure 2-42. Wedge Down

Figure 2-43. Wedge Up

Figure 2-44. Scarpa

Suppression Plate (SSP)

Chapter 2 doc.qxd 7/18/05 4:00 PM Page 23

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 83 84

No comments

Malibu Boats Boat Specifications Page 43